Heated and Vacuum Applicator or Press are built to order to suit your components.

Retains proven technology and design features of the standard range of Laminating technology products.

All designs fully modelled in 3D before construction to ensure design optimization.

Precision steel fabricated chassis, providing very strong construction.

Adjustable vacuum so you can set the bonding pressure to suit different materials.

Lifted vertically by pneumatic rams fitted with safety valves.

Lubricated rotary vane pump provides higher pressures than equivalent dry pumps.

Assembly table allows panels to be assembled outside the press and then rolled in using the castors.

Click on an image below to open pdf

HVP-3

HVP-5

• Precision fabricated steel chassis
• Modules fitted with adjustable levelling feet
• Working height 800mm from ground to bed surface
• Perforated steel press bed mechanically fixed and sealed to chassis
• 1.5mm thick flexible latex membrane fitted into a fabricated steel frame
• Vertical lift to membrane frame by pneumatic cylinders fitted with safety locks
• Oil lubricated Rotary Vane Vacuum Pump rated at 70 cubic metres per hour
• Vacuum adjust valve

     Optional

• Retractable loading castors fitted to press bed with pneumatic operation

Control box with:

• Vacuum pump on/off push buttons
• Membrane raise/lower push buttons
• Loading castors raise/lower push buttons
• Curing cycle timer
• Vacuum gauge
• Mains isolator
• Emergency stop switch

Click on an image below to enlarge

Use the 'Back' button to return